Yorkville YSM8 User Manual download pdf (Page 6)

YS M

5. Low Frequency Control Settings (YSM6 and YSM8)

The default setting for the LF (low frequency) is 0. As an example, if the monitors are

placed in the middle of a room and more low end response is needed, set the select

switch to +1.5 A. As another example, if your monitors are placed against the back wall

as shown in the diagram below, it is recommended that you set the LF setting to -1.

Accordingly, if the monitors are placed in the corner of the room, set to -2.

6. Bi-Amplification

The common term is bi-amplification, a process which uses two power amplifiers and

an electronically accurate ‘active’ crossover network. This type of crossover network

divides the signal much more precisely than traditional passive crossover networks. All

three monitors, the YSM5, YSM6 and YSM8 use bi-amplification, an amplifier dedicated

for the tweeter and another for the woofer.

Full Space Placement

(full area)

1/2 Space Placement

(against the wall)

1/4 Space Placement

(in corner)

LF Presets

-2+1.5 -1

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Yorkville YSM8 User Manual Page 6