YORKVILLE YX10SP Owner's Manual download pdf (Page 4)

YX SERIES

3. Link Jacks

The Link jacks are directly connected to the input jacks, use these jacks to send your source signal

on to additional YX10SP subs.

4. High Pass Output Jacks

High Pass output jacks are provided to eliminate the need for an external crossover. Use

these jacks to feed the input of your full-range loudspeakers. The signal from these XLR jacks

has had the audio below 80 Hz rolled-off, allowing for a flat system response when feeding

the full-range loudspeakers.

5. Ground Lift Switch

In normal operation, keep the Ground Lift switch in the depressed position. If an audible hum is

present in your system, try “lifting” the ground to break a ground loop in your system.

6. Protection and Indicators

The YX10SP has circuitry to prevent clipping, over-current and over-excursion. At high power levels

the internal limiter will limit the gain of the YX10SP. The level control should be set while operating

at low levels (under 10 watts). If the level control is set too high, the input circuit will clip and the

dynamics of the bass will be lost. If the user tries to set the subwoofer level control at a high level,

the resulting setting will be incorrect.

In normal operation, the rear LED indicator will flash green when a signal is present. When the

indicator starts flashing red, the limiter is engaging. Increasing the input signal beyond this point

will potentially result in undesirable audible clipping.

AT HIGH POWER LEVELS WHEN THE LIMITER IS OPERATING INCREASING THE SUBWOOFER

LEVEL CONTROL WILL NOT INCREASE THE OUTPUT. DO NOT INCREASE SETTING WHILE

OPERATING AT HIGH LEVELS.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

YORKVILLE YX10SP Owner's Manual Page 4