Yorkville PGM8 User Manual download pdf (Page 11)

Rear Panel

1. Power Switch and Fuse

The power switch is located on the rear panel. It is unlikely that the fuse would blow but if

there is the suspicion that the fuse has blown first:

i. Confirm that there is 120VAC/230VAC at the point where the PGM8 power plug con-

nects to either a wall plug or an extension cord.

ii. Confirm that the power switch is turned on.

iii. If the PGM8 Power LED is still off disconnect the AC power cord from the PGM8.

iv. Use a screwdriver to slide out the fuse drawer located on the IEC AC power

socket of the PGM8.

v. If visually you can see that the fuse is blown replace with the same type

500mAL sloblo type fuse. It is very important to replace the fuse with exactly

the same type of fuse.

vi. If when powering up the PGM8 with the new fuse the fuse blows again then your

PGM8 may require service from an authorized service technician.

2. Phantom Power Switch

Phantom Power is available for condenser microphones. Even though dynamic microphones

do not need phantom power, having the phantom power turned on will not harm dynamic

microphones. When connecting microphones it is safest to turn off the phantom power to

avoid loud pops. The Phantom Power switch is located on the rear of the mixer. Beside the

Power LED the Phantom Power LED is in the upper right area of the control panel.

To obtain the best performance from your condenser microphones 48 Volt Phantom

Power is available on channels 1 through 8.

3. Main Out XLR Jacks

The main out left and right XLR jacks are located on the rear panel. These are true low

impedance balanced outputs. For the best noise immunity use well shielded XLR cables.

Input Wiring tips:

1. For all input connectivity use shielded wire only. Cables with a foil shield or a high-

density braid are best.

2. When changing input connections, turn down the level controls on the mixer to

eliminate pops and thumps out of the loudspeakers.

3. Keep input connection cables as short as possible to minimize noise and hum.

FUSE: T0.5AL 250V sloblo

ATTENTION: UTILISER UN

FUSIBLE DE RECHANGE DE

MEME TYPE ET CALIBRE

CAUTION: REPLACE WITH

SAME TYPE FUSE AND RATING

DISCONNECT POWER

BEFORE SERVICING!

DEBRANCHER L’APPEREIL AVANT

D’ENLEVER LES COUVERCLES!

THIS UNIT MUST BE

GROUNDED!

CET APPAREIL DOIT

ETRE MIS Á TERRE!

• TORONTO, CANADA •

MADE IN CHINA

Power

48 Volt

Phantom

90-264 VAC 50-60Hz

60 VA MAX

MAIN Out

MODEL TYPE:

YS1096

A-PGM8-BK / 3v0

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments

Yorkville PGM8 User Manual Page 11

Comments to this Manuals

Related products and manuals for Acoustics Yorkville PGM8